The test and inspection of board-to-board connectors

There are the test checks for board-to-board connectors.

1. Observe that the loading voltage on the board-to-board connector and it does not exceed 50% of its rated voltage.

2. The length of the soldering feet on the soldering PCB should expose the part of the PCB board above 0.5MM.

3. For the board-to-board connectors with higher precision, use the positioning model as much as possible when the PCB space allows, so as to facilitate the operation during manual welding.

4. Check if the material used by the board-to-board connector contains lead.

5. Pay attention to observe the height of the board-to-board connector after mating, whether it meets the soldering height of the components around the PCB. The matching height must be greater than the soldering height of the components around the PCB, and a certain margin is guaranteed to ensure that no interference will occur.

6. The insulating material of the electronic wire connector should not be exposed to the sun and rain. The packaging should also not be damaged.

7. Store the insulation material of the electronic wire connector in a clean, cool, dry and ventilated warehouse.